T3 won't mount shares after 19.3 firmware install

sddawson · Post by **sddawson** » Wed Jan 22, 2020 12:32

I have 4 Beyonwiz boxes - a T3, 2 x T4s and a U4. I've just installed the 19.3 firmware on all the boxes. All but the T3 are fine. On the T3, I can't get any shares to stay mounted. Through the Network Browser, I do the normal process of expanding a server (say, one of the other BW boxes) and choosing a folder to mount. I save the mount, and get the normal messages about the activation being successful. Then, in the Mountpoint Manager, I can see the mount but it is unmounted (has the red X against it). Sometimes, I can go in and re-activate the mount, replacing the previous one, and it will show as mounted, but only for a short while.

The exact same process works on all the other 3 boxes. I have re-downloaded and refreshed 19.3 on the T3, even starting afresh without a settings restore. No go.

Ideas? Any known problems with 19.3 on a T3?

Grumpy_Geoff · Post by **Grumpy_Geoff** » Wed Jan 22, 2020 13:27

Try removing the ",vers=2.1" parameter from the Mount options for the mount in the Mounts editor/Mountpoint management.

sddawson · Post by **sddawson** » Wed Jan 22, 2020 13:45

Grumpy_Geoff wrote: ↑
Wed Jan 22, 2020 13:27
Try removing the ",vers=2.1" parameter from the Mount options for the mount in the Mounts editor/Mountpoint management.

These are mounts between the BW boxes, so that shouldn't be necessary should it? Also, all the mounts on the other boxes have the 2.1 string, and they all work fine. Incidentally, all the mounts are set up with no login credentials. Thanks for the help.

Grumpy_Geoff · Post by **Grumpy_Geoff** » Wed Jan 22, 2020 14:00

sddawson wrote: ↑
Wed Jan 22, 2020 13:45

Grumpy_Geoff wrote: ↑
Wed Jan 22, 2020 13:27
Try removing the ",vers=2.1" parameter from the Mount options for the mount in the Mounts editor/Mountpoint management.
These are mounts between the BW boxes, so that shouldn't be necessary should it? Also, all the mounts on the other boxes have the 2.1 string, and they all work fine. Incidentally, all the mounts are set up with no login credentials. Thanks for the help.

Did you try it?
I recall reading that the T3 specifically had issues with the ",vers=2.1" parameter on 19.3-series firmware.

Edit -
Here - viewtopic.php?f=56&t=13693#p182971

sddawson · Post by **sddawson** » Wed Jan 22, 2020 18:55

Grumpy_Geoff wrote: ↑
Wed Jan 22, 2020 14:00
Did you try it?
I recall reading that the T3 specifically had issues with the ",vers=2.1" parameter on 19.3-series firmware.

Edit -
Here - viewtopic.php?f=56&t=13693#p182971

Well I'll be, yes it fixes it. I had thought of trying that, but I really didn't think there would be a difference in the SMB implementation between the platforms. But I see from the thread you posted it's a slight omission that will be fixed. Thank you!