NOTE: the following romote control setup assumes the bwiz has been upgraded to December 01.05.192 firmware or later.
gnoop, I use the very simple method which I posted earlier. The purpose of the following romote comand is to clear the popup warning when a user tries to turn the bwiz
on , but it is already on and recording..
I dont see the need to add any extra turning off commands, because the warning that pops up if the bwiz is recording handles the situation on its own.
A more detailed description of what I have done:
Run the Harmony romote software:
Select
Settings for the activity then,
Review the settings for this Activity then,
Yes, but I want to add more control of options and devices for this Activity then
I just click Save and go though the next couple of screens till I get to:
Please review the actions for your Watch TV Activity:
When you enter this Activity, these devices are turned on and the following actions occur:
Then I used
Add action for and selected the Beyonwiz
then select
Add then
select
Exit or
Cancel from the drop down list and then saved the changes.
For the Beyonwiz
Device , I have the power settings set to:
want to turn off this device when it's not in use
and the next screen;
One button on the remote for turning it both On and Off which is Power Toggle
Save the new settings to the romote control.
They are the only commands I have set up for the beyonwiz and it works fine