1.5.280 Customisable Skipping

[Vortical]

While the S1 has Left and Right Customisable Skipping measured in seconds and Up and Down Measure by % The H1 is different for some reason.

I have performed a factory reset and see the following
Left Skip is measured by %
Right Skip is measured by Seconds
Up Skip is measured by %
Down Skip is measured by %

I've tested it to see if it's just a visual error but it's not.

This is going to be a real pain for anyone streaming on a H1 with no backwards skip anywhere near 10 seconds

The best I could get was -2% which was still about 1 minute on a 1 hour show.

[IanSav]

Hi Vortical,

In the SETUP menus did you try to use the OK button to change the units between % and seconds skips?

Regards,
Ian.

[Vortical]

Thanks Ian

I must have accidentally pressed OK.

Wasn't aware you could switch between percentage and seconds.

[prl]

Thanks Ian

I must have accidentally pressed OK.

Wasn't aware you could switch between percentage and seconds.

The help bar at the bottom says that OK is for "Change Units" when the arrow key config is selected. Perhaps that could be clearer.

[j s]

Thanks Ian

I must have accidentally pressed OK.

Wasn't aware you could switch between percentage and seconds.

The help bar at the bottom says that OK is for "Change Units" when the arrow key config is selected. Perhaps that could be clearer.

That's probably clear enough once noticed - but I didn't spot it until after reading it in the forums.

Another case of RTFH